In the process of wallpaper paving, many people believe compared with parquet wallpaper, plain wallpaper is very Simple Wallcoverings simple and more convenient to use without mosaic. It turns out that ordinary wallpapers are simple and easy to construct because they haven’t any patterns, however the relative stitching requirements are even more stringent. Plain colors, especially darker plain shades, are relatively more prone to seam problems. If the ordinary wallpaper has a seam phenomenon, what’s the explanation for judging the seam? Then take the correct approach.
1. There is a gap
If the seam sometimes appears at 1.5m on leading side, there is no color difference in the wallpaper. Is it serious to handle the seams during construction? Most of the causes of the seams are caused by construction problems.
1. If the wallpaper is usually a rubberized wallpaper, you can wet the seam with a wet towel, open up the wallpaper glue, carefully pry open the wallpaper, and use the wallpaper softener to soften the wallpaper to extend the wallpaper and restoration the seams.
2. If it’s a real paper wallpaper or a nonwoven wallpaper, there is nearly no stretchability, so that it can’t be repaired by the above method. The base could be shaded with a paint-coated seam that is identical in color to the wallpaper.
2.Yin and Yang
When there is obviously no overall feeling between your wallpaper strips at 1.5m on leading side, the seams of the wallpapers are handled good in close distances, and there is no obvious seam phenomenon. It appears that the wallpaper looks like a color difference, and the colour difference at the seam can be in accordance with the obvious law of deep-shallow-deep-light or shallow-deep-shallow-deep, which may be caused by the yin and yang.
Find the label of this wallpaper and see if there is an alternate label at the top and bottom of the label – ↑↓.
1. If there is, it requires to be alternately pasted based on the logo, ie: shallow-shallow-deep-deep in accordance with avoid the phenomenon of yin and yang.
2. If there is no logo, it is caused by the quality issue of the wallpaper. There is absolutely no solution and it is necessary to react to the wallpaper sales workplace.
3 white side
If underneath paper is available to be slightly longer when the dark wallpaper is constructed, you will see a white edge at the seam after the construction. The gap is usually clearly visible far away of just one 1.5 m from leading of the wall.
1. Because the wallpaper is not constructed with plain wallpaper, the seam can be treated by the method of edging.
2. If the wallpaper has been constructed, it can be utilized in the same color as the wallpaper. (That is a versatile method)
4 overflow glue
The plain wallpaper is not easy to erase after filled with glue, and there are residual rubberized marks after rubbing.
1. When constructing, be sure to check whether there is an “along alternate” construction mark on the wallpaper label. When there is this logo design, the wallpaper ought to be positively and negatively posted. When there is still a positive and negative surface phenomenon, you can test normal stickers again.
2, plain color non-woven wallpaper construction should try to avoid spilling glue, avoid wiping, once the wiping strength is normally large, it could leave traces. If you are unfortunate plenty of to spill the glue, you should clean the spilled glue in the smallest range, and the softer color of the basic wallpaper should be gentle.
3, rubber surface ordinary wallpaper, the first wallpaper paste for half an hour must pay attention to check whether the seams of the wallpaper have got offset printing. If there is offset printing, it means that the rubberized wallpaper can’t overflow, and the glue will keep traces.