Categories
Wallpaper

How to strip old wallpaper? Give you a few small tricks!

Many owners do not know how to cope with the previous wallpaper about the wall when replacing the wallpaper; in the event that you continue to paste fresh wallpaper on the older wallpaper, the outdated and older wallpapers may fall off the beaten track together because of the moisture of the adhesive. The ultimate way to do that is definitely to strip the previous wallpaper to ensure that the wall structure covering sticks to the wall structure more firmly.
Here are some methods to uncover old wallpapers.
Peelable wallpaper
1. Pick and choose an inconspicuous corner near the top of the wall and use the tip of the utility knife to get the wallpaper.
2. Try to be close to the wall, pinch the part of the wallpaper, and try to take it off from the wall. Strip the wallpaper in your direction, which makes it easier to take away the wallpaper. Whether it’s a peelable wallpaper, the wallpaper will detach from the wall so long as you are strenuous and moderate.
Cut and infiltrate
1. Use a computer program knife, razor blade or wallpaper scraper to cut the outdated wallpaper horizontally, each slit is about 20 or 25 cm apart.
2. Apply water or wallpaper remover and wait a few minutes for the wallpaper to completely saturate.
3. Repeat the same procedure on the next wallpaper strip, then return to the 1st strip and re-wet it throughout with the formulation.
4. Start stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Starting from a slice horizontal wallet, the blade is certainly placed under its upper edge and the blade is at an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper that is the same width as the Original Wallcoverings squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue steadily to push down before wallpaper can’t be taken off. If the scraped wallpaper tape breaks, re-infiltrate this region and start to scrape another tape.
Steam method
It is not simple to peel from the lime old wallpaper. You can lease a steam engine, nevertheless, you still need to make use of a wide-blade putty knife to scrape the majority of the wallpaper.
1. Following the water is scorching, press the steam plate on the wall before wallpaper on the edge of the steam plate becomes dark because of moisture. Focus on a strip of paper and gradually peel from the lime the wallpaper throughout.
2. After steaming half of the paper strip, use a nail or a computer program knife to draw up the part of the top of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it can be scraped off with a wall scraper. You might want to steam the same region twice or 3 x to loosen the adhesive for the much longer a few months of the wallpaper.
alcohol
For waterproof coatings, cleaning the wall paper glue with alcoholic beverages will not cause much harm to the wall. Instead, the volatilization of alcohol can minimize the harm to the wall structure. But one thing to note is that the concentration of alcohol should not be too high. Normally, the volatility is certainly too large, and it is easy to make the white wall turn yellow or black. This is an extremely bad phenomenon.
salt
This technique uses physical friction. But because salt is usually a white crystal, you don’t have to worry about the unusual color that the friction brings to the wall. In the process of rubbing, you may use white gauze or cloth that can hold salt, pack a small packet of salt, gently rub, slowly you will find that the glue still left on the wall structure paper is slowly disappearing, and stuck in At the top of the fabric, you merely need to rub and stop to remove the glue from the gauze. The next thing is never to be said.